Technical and mechanical design

The device can be mounted on a standard rail or on the wall.

1

Plastic housing

2

LEDs for communication and state

3

Service button

4 a)

2-port Ethernet switch with 2 LEDs per port

4 b)

Not supported

5

Plug-in terminal blocks with screw terminals
Power supply

6

Not supported

7

Not supported

8

Not supported

9

Slider for mounting on standard mounting rails

10

Eyelets for cable ties

11

Holes for wall mounting

12

Date / Series and Serial number

LED indicators and service pin

Activity

LED / Interface

Color

Activity

Function

Ethernet 1...2

Green

Continuously ON
Continuously OFF
Flashing

Link active
No connection
Network traffic

Yellow

Continuously ON
Continuously OFF

Link 100 Mbps
Link 10 Mbps

RUN

Green

Continuously ON
Continuously OFF
Flashing

Device operational
Device not operational
Start-up or program halted

Red

Continuously OFF
Continuously ON

Rapid flashing

OK
HW or SW fault - power off and on the device
Firmware or application missing/corrupted

Blue

Steady ON
Blinking

Steady OFF

Cloud connection OK
Cloud connection enabled but no connection available
Cloud connection disabled

SVC

Red

Continuously OFF
Flashing

OK
Device is not configured

Flashing per wink command

Identification of the device after receipt of wink command

COM1 / 2 TX

Yellow

Continuously OFF

Function not supported

COM1 / 2 RX

Yellow

Service button

 

Short press

Identification on the network

As per description:

Do the following to reset the device to factory state:

  1. Power off the device.
  2. Power on the device.
  3. Wait until all LEDs light up and turn off again, then press the Service button.
  4. Keep the Service button pressed until all LEDs light up, then release the button.
    All LEDs turn off, the device restarts.
  5. Wait until the device has fully started up – unconfigured (green RUN LED and red SVC LED are flashing).